Features of Armedica AM-BAX 2000 Two Section Hi Lo Treatment Table
- It is equipped with a full length bar activated Hi-Lo control along both sides of the table
- 4 Caster Base with 4″ Total Lock ball bearing casters
- The center section is motorized to allow positioning with the patients full weight on the hi-lo table
- The center section motor controls are located on each side of the center section to allow adjustment without losing contact with the patient
- Contoured Face/ Nose Opening and X-frame design
- Armrests have a range of 6″ vertical adjustment while remaining on a plane with the center section
- Dimensions:76″L x 27″W x 19″ – 38″H
- Capacity (lbs): 400lb
- Top Section: Two Piece
- Head Section: 15″ x 13″ Raises 25 degrees – Lowers 80 degrees
- Body Section: 57″ x 27″
What to buy with Armedica Treatment Table
- Medline Medsoft Reusable Pillows
- Medline Blue Tissue/Poly Drape Sheet
- BodySport Cervical Roll Pillow
How to use Armedica 2-Section Hi-Lo Table?
- Remove all packaging material from the tables
- There is no assembly required on ARMEDICA Treatment Tables
- Plug the power cord into a properly grounded 120 Volt AC outlet and follow the procedure outlined in the Precautionary Instructions
- The table is equipped with four total lock swivel casters for maximum stability
- The motor is equipped with a thermal cutout that protects it from overheating
Instructions while using AM-BAX 2000 Two Section Table
- Read, understand and practice the precautionary instructions in this manual. Know the limitations and the hazards associated with ARMEDICA Treatment Tables.
- The motor is double insulated for protection from EMI
This equipment has been tested and found to comply with the limits for medical devices
These limits are designed to provide reasonable protection against harmful interference in a typical medical installation
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to other devices in the vicinity.
However, equipment does cause harmful interference to other devices, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving device.- Increase the separation between the equipment
- Connect the equipment into an outlet on a circuit different from that to which the other device(s) are connected
- Consult the manufacturer or field service technician for assistance
- Always make certain all four casters are locked prior to patient use
- Always use both hands when changing the angle of any section of the table
- Never change the angle of any section when the patient’s weight is on that section
- Never place your hands or feet nor the patient’s hands or feet near any of the working mechanisms of the table when raising or lowering the table
